Adding and Removing Data Center Nodes

Your Data Center license is based on the number of users in your cluster, rather than the number of nodes. This means you can add and remove nodes from your Data Center cluster at any time. 

Adding a node

To add a node:

  1. Copy the installation directory and local home directory from the stopped node to your new node.
  2. Start Confluence on your new node.
    During the startup process Confluence will recover indexes from a running node to bring the new node up to date.
  3. Go to  > General Configuration > Clustering and check that the new node is visible.

You should only start one node at a time. Starting up multiple nodes simultaneously can cause serious failures. 

Removing a node

To remove a node, stop Confluence on that node.  You can then remove the installation and local home directory as required. 

To see the number of nodes remaining go to  > General Configuration > Clustering.

Was this helpful?

Thanks for your feedback!

Why was this unhelpful?

Have a question about this article?

See questions about this article

Powered by Confluence and Scroll Viewport