[Bamboo Knowledge Base]
This page describes how to configure Bamboo to use a Bitbucket source repository for either a plan or a job.
Before you start:
To add a new Bitbucket repository, navigate to the source repository settings for a plan or job, as described on Specifying the source repository.
|Retrieves all repositories you have explicit permissions to access from Bitbucket when you click Load Repositories.
|Pick a branch if you want to check out code from a branch other than the default branch.
|This is useful to stop hung Bitbucket processes. On slower networks, you may consider increasing the default timeout to allow Bamboo time to make an initial clone of the Mercurial repository.
For Mercurial: Turns on
|Enable Quiet Period
|Specifies a delay after a single commit is detected before the build is started. This allows multiple commits to be aggregated into a single build.
Allows you to specify the files that Bamboo should, or should not, use to detect changes.
|Enter a regular expression to match the commit messages for changesets that should not start a build.
If your repository can be viewed in a web browser, select the repository type.
This allows links to relevant files to be displayed in the 'Code Changes' section of a build result.
Mercurial Web Repository – select one of the following viewer schemes: